Electronic Engineer Discuss

Title: DSO3000A trigger的问题 [Print this page]

Author: arthurwang Time: 2017-4-26 19:17
Title: DSO3000A trigger的问题

状况描述:

CH1 选择 X10,

Trigger Sweep: Auto à 正常

Trigger Sweep: Single à 当trigger到暂停时, 原本X10的画面会变成X1

Author: amy Time: 2017-4-27 14:33

请上传图片看一下。

Author: arthurwang Time: 2017-4-27 19:17
设置软件选择选择X10。设置探头衰减系数X10。
将探头端部与探头补偿器的信号输出连接器相连
并已经已经下载最新 Firnware version: 1.0.1

Author: amy Time: 2017-4-28 09:00
请在以下对话框的命令框里输入“system:version?”，然后点“Send&Read”，并上传截图。
[attach]1491[/attach]

Author: arthurwang Time: 2017-4-28 18:20
Please refer it, thanks!

Author: amy Time: 2017-5-2 13:33
Please register a username and login to download the latest firmware on our official website: http://hantek.com/en/ProductDetail_2_134.html
And refer to the document in the package to update the firmware.

Author: arthurwang Time: 2017-5-2 20:26
已经更新Firmware版本: 20161204A (如下图)
但是结果一样, 问题还在, 还请帮忙, 谢谢!

Author: amy Time: 2017-5-3 08:24
不好意思。网站上的固件已更新，请再次下载新的固件后升级。

Author: arthurwang Time: 2017-5-3 10:32
更新Firmware后已经操作正常, 感谢!

Welcome to Electronic Engineer Discuss (https://www.eediscuss.com/)