Forum › Desktop Oscilloscope › DSO5202B firmware updates fail with 0xfe

dgScope Publish time 2019-5-16 08:28:57

DSO5202B firmware updates fail with 0xfe

Edited by dgScope at 2019-5-18 04:50

I’ve tried upgrading the firmware on my DSO5202B using the files below, and both resulted in 0xfe errors (no update file found).
dso5kb_func_dso5202b20140610.updso5kb_func_dso5202b20180226.up
These firmware files were obtained from the Hantek website and the Hantek OneDrive account.
I tried multiple FAT32-formatted 1GB USB flash drives.The flash drives are otherwise operational with the scope.I can save waveforms and screenshots to USB ok.I've reformatted so the only file present is the firmware up file.No luck.
Any help would be appreciated.
Scope S/N: T 1G/200M 033099SW version: 2.06.3 (130814.1)HW version: 0x555583e9
Thanks

amy Publish time 2019-5-18 13:23:11

Sir, your scope is too old, the new firmware is not suitable for it.
Please send a message to our email support@hantek.com

dgScope Publish time 2019-5-21 05:16:51

I did follow up with support@hantek.com and haven't received a response.

My question to Support is:What’s the highest supported firmware version for the DSO5202B with hardware version (0x555583e9)?

Thanks.

amy Publish time 2019-5-25 16:28:12

Edited by amy at 2020-2-14 10:02

Sir, the linux version of your scope is 2.06.3. The latest firmware is not suitable for it.
Please use this firmware to update.


Attention, if the firmware version number earlier than 2013, such as 120505.0 or 120825.0, please do not upgrade with this firmware.

Slash200 Publish time 2020-2-4 03:54:13

Dear Amy,
I have the same problem.
Model: DSO5202B
SW: 2.06.3.(130425.0)
HW: 10070x555583e9
I can't update from the downloads from the hantek page.
Also your attached update shows me the error 0xfe
Can you please help me updating my DSO?

Thank you!
regards

amy Publish time 2020-2-14 09:58:42

Slash200 replied at 2020-2-4 03:54
Dear Amy,
I have the same problem.
Model: DSO5202B


Sir, You can upgrade with the above firmware.

cdidier Publish time 2020-3-10 01:22:43

Hello Amy,

I have the same problem too. But my firmware is quite older:
Model: DSO5202B
SW: 2.06.3(120808.0)
HW: 10070x555583e9

What is the procedure to update my device?

amy Publish time 2020-3-13 16:33:36

Sorry, there is no upgrade firmware suitable for your oscilloscope.

JSP40 Publish time 2020-5-1 15:59:35

I have the same problem.
DSO5202P
Firmware update failed error 0xfe
No upgrade files detected on USB device

BeanieBob Publish time 2020-5-3 21:40:52

I had this problem before with files not visible.
I suspect the USB partition cannot be mounted because the drive capacity is too large.
I was able to use an old 512MBUSB stick successfully.

Can you try with a small capacity USB drive - or possibly create a small partition
if you do not have an older USB stick. Hope it works for you.   

( I am not from Hantek - just a user - so this is not official advice)

View full version: DSO5202B firmware updates fail with 0xfe