Mik3 Publish time 2021-10-21 04:21:38

New DSO2c10 broken, calibration error

Edited by Mik3 at 2021-10-21 04:23

Hi, channel 1 trace on my scope wont center, its as if there a DC voltage offsetting the trace, I only bought it last month and only used it a few times, I tried to use it tonight to test a low pass filter and the trace is right at the top of the screen. So I tried to calibrate it and it gives this error 510d6, I tried rebooting several times and then tried a different firmware but nothing works.

Jing Publish time 2021-10-23 09:59:14




Please make sure to warm up for at least 30 minutes before calibration.

tauirene2007 Publish time 2021-11-2 11:48:45

hi,
my new DSO2D10 do the same.
Calibration does not work even after 2 hours warming up.

Hardware failure ? or only software

Jing Publish time 2021-11-3 09:02:49

tauirene2007 replied at 2021-11-2 11:48
hi,
my new DSO2D10 do the same.
Calibration does not work even after 2 hours warming up.


Please send your questions to support@hantek.com.

OLMa Publish time 2022-1-31 04:52:24

Hi, channel 1 and 2 trace on my scope same wont center, its as if there a DC voltage offsetting the trace.
Hardware failure ? or only software?
Pages: [1]
View full version: New DSO2c10 broken, calibration error