Title: IDSO 1070A signal distortion [Print this page] Author: Jeffrey Time: 2019-3-12 15:49 Title: IDSO 1070A signal distortion Dear Hantek service,
I got a good tool(Oscilloscope) for cabling to wireless at begin.
But I have problem to test on my devices (Not each device has the symptom)
When I span signal the wave seems good, but if view overall signal then wave seems distortion.
Here is what I experiment as below
I checked two devices have similar period (1/4.8MHz).
According to Nyquist theorem if the signal without distortion the lowest sample rate must double real signal frequency.
Is it the software display problem?
Can I do anything improve it?
BTY, do we have higher sampling rate wireless oscilloscope?(One of my suspect is low sample rate)
Sorry, I can't see what time base you set.
What is the current sampling rate displayed on the software? Author: hermiane Time: 4 day(s) ago
One Stop Student Portal is here to serve you best with its user-friendly and straightforward approach to providing an accessible and uncomplicated website experience. Everything you need to know about the courses you wish to take, online activities, and more is available at the UNICCM student portal. Experience advanced learning through UNICCM. facilities management diploma mciob course apc pathway guide
Welcome to Electronic Engineer Discuss (https://eediscuss.com/)