|
Edited by Oleg10011001 at 2016-7-19 23:40
Well, after a firmware update, I see that everything I described in the previous report defects were not corrected. Maybe you want to illustrate the flaw in the cursors measure voltage in "Track" mode, the type of cursor measurements. So, like so cursors appear when switching in the Cursor type "Track" mode:
As can be seen, initially measuring the voltage cursors are not attached to the waveform and measure is not clear what. This is the cosmetic defect. Should I just move my cursor "S" or "E" followed by the associated arrow cursor related to the measurement of the voltage takes place allotted to him on the trace:
Then cursor measurements are operating normally. However, if you turn off mode cursor measurements oscilloscope probably remembers the position of the cursor related to the measurement of voltage and the next time the cursor measurement mode to "Track" without looking puts cursors measure voltage at the places where they were in the previous session, cursor measurements. The problem here is that between the previous session cursor measurements and waveform current session could be shifted, and in the end this is what happens:
Here, too, enough to move cursors "S" or "E" and the associated cursor related to the measurement of the voltage takes place allotted to him. It also happens that after stirring of the cursor "S" put them to the place occupied at once both cursors measure voltage. Described defect occurs only once after the switch in the type of cursor measurement mode "Track" and disappears after the start of the use of cursors. To remove this cosmetic defect, it is necessary that when you switch to cursor measurement type "Track" mode cursors measure voltage immediately be installed in the normal position, corresponding to the current cursor position "S" and "E" on the waveform.
|
|