|
Edited by lichtrov at 2016-6-14 16:54
I have a few questions regarding the integrated generator:
1. Maximum amplitude of +/-3.5V (specified in the datasheet) into 50 Ohm load or into Hi-Z load? Please, set 1kHz sine waveform with maximum amplitude. Could you, please, just measure the maximum amplitude by connecting generator output to oscilloscope input?
2. DC Offset – what are (a) maximum and minimum limits and (b) resolution? Please, set 1kHz sine waveform with maximum amplitude and check what are the limits of DC offset. Is waveform on the oscilloscope screen undistorted?
3. Duty Cycle – what are (a) maximum and minimum limits and (b) resolution? Please, set 1MHz square waveform and check what are the limits of duty cycle.
If you could answer it will be greatly appreciated.
|
|