|
Edited by Oleg10011001 at 2017-1-8 15:23
And another point on which I would like to draw your attention more specifically requested. When the oscilloscope operates as a single-window mode, press on the "SEC / DIV" has no function. Please do so by clicking on the "SEC / DIV" sets the minimum sweep time (2ns). Also I would like to see by clicking on "Vertical position" of both channels and the "Horizontal position" could move the corresponding markers not only in the center of the screen, but also on the two edges of the screen (on the extreme line). That is, when you click on these controls appropriate markers on the line to move to the specified position. Similar changes would like to see in the management of the cursor by moving the cursor in the measurement mode. This would make the work more comfortable with an oscilloscope.
|
|