Jing replied at 2021-12-13 16:51
Open the machine to see if there is an SD card in the SD card slot. If there is an SD card, short ...
Thank you for your advice.
I'm on a business trip right now, so I'd like to try it when I get home.
Open the cover and look for the SD card.
Is the P5 terminal a pin in the SD card slot?
And it would be very helpful if you could tell me the pin number to short the P5 terminal.
I tried to calibrate after warming up for about 1 hour without connect ...
Open the machine to see if there is an SD card in the SD card slot. If there is an SD card, short the P5 terminal with a wire, then turn on the machine to automatically program the program, and then try the self-calibration after the program is programmed.
I tried to calibrate after warming up for about 1 hour without connecting anything, but it was also "ERROR: 520d4".
(I wrote "ERROR: 502d4" yesterday, but "ERROR: 520d4" is correct)
I downloaded the firmware again and tried updating it again, but it didn't work either.