|
Edited by Codebest at 2017-12-14 10:17
In ver 2.1.31 and 2.1.34 choosing Acquire / Interpolation / Linear is causing strange behavior on the 50 ns and 100 ns time-base settings. The same issue does not occur on the step or sin(x)/x settings.
This was produced by choosing Utility / Factory setup followed by the AUTO button on CH1. This is a 100 Mhz sine was from an HP signal generator. It works perfectly in step or sin(x)/x modes. and it also works perfectly fine on any other time-base other than 50 ns and 100 ns when in linear interpolation mode. This does not appear to be a hardware issue, it appears to be software related. I've not found a work around so far.
This is a pure sinewave being fed to the scope, not a burst.
|
This post contains more resources
You have to Login for download or view attachment(s). No Account? Register
x
|