Problem hantek 6022be

Galfo · Post time 2016-5-30 10:38:33

Hello
I have a problem with the 6022be oscilloscope. when I connect the probe to a voltage below the 5v the right law , while for any voltage over 5v I find a value of 5,18v voltage . for example if you connect the probe to a 12v battery 5,18v reads me . how do I fix ?

amy · Post time 2016-5-30 10:45:29

Dir sir,
The max. measure voltage is -5V~+5V without any attenuation. The max. measure voltage is -50V~+50V with 10:1 attenuation.
When you want to measure the voltage over 5V, please change the attenuation to 10:1.

Galfo · Post time 2016-5-30 17:49:50

thanks for the reply .
In the channel because it says 35V max ? I can read voltages above 35V with attenuation commissioning probe to x10 ?

amy · Post time 2016-6-1 08:42:11

Galfo replied at 2016-5-30 17:49
thanks for the reply .
In the channel because it says 35V max ? I can read voltages above 35V with ...

The input protection is 35V. If the input voltage is over 35V, the device will be damaged.

Problem hantek 6022be

This post contains more resources