Electronic Engineer Discuss
Title: Shutdown(Sleep) setting [Print this page]
Author: ying Time: 2019-4-17 10:39
Title: Shutdown(Sleep) setting
Edited by ying at 2019-4-17 10:45
Customer Consultation
I have a Hantek DSO1202B scope and IM find that, after not pushing any buttons for a while, the scope goes into stand-by (sleep?) mode. I can wake it up by touching any button. Is there a way to tun off the standby (sleep) function? I apologize if I have missed it in the manual.
My serial number is DS00504666 and the firmware is 2.01.1 (170908.0).
Author: ying Time: 2019-4-17 10:43
Reply
Please press "Utility->F5" to page to 2/5 and select "Shutdown" to set poweroff time as a long time. Please refer to the following picture.
Author: zkakuszi Time: 2019-11-27 20:46
Hi .. my one is DSO1062B .. and I can set the time .. and confirm, but it is going to switch off in one minute anyhow
At the first sight .. help!!
Author: amy Time: 2019-12-2 16:46
If you cancel the automatic poweroff, what's the result?
Author: ying Time: 2020-12-22 08:49
Please try to set the backlight keep time as "Unlimited".
Press "Utility" button and F5 to page 4/5 as the below figure.
[attach]4064[/attach]
Then press F5 to page 3/3 and set the backlight keep time as the below figure.
[attach]4065[/attach]
Author: BurakBey Time: 2021-2-28 19:09
Can we change the backlight duration unlimitedly and create a profile that saves the changes? In order not to need to be adjusted every time
Welcome to Electronic Engineer Discuss (https://eediscuss.com/) |
Powered by Discuz! X3.2 |