Electronic Engineer Discuss

Title: How to use the Digital Generator on the waveform generator of HDG6000B? [Print this page]

Author: WisdomAugust Time: 2019-6-10 08:03
Title: How to use the Digital Generator on the waveform generator of HDG6000B?
[attach]2919[/attach]

Author: WisdomAugust Time: 2019-6-11 08:10

Review the Output Terminal

Signal Output Terminal Under Device Display

[attach]2930[/attach]

Output Terminal On Digital Generator Interface

[attach]2931[/attach]

Terminal Description

[attach]2932[/attach]

Note: Vcc: 3.3V

Author: WisdomAugust Time: 2019-6-12 08:15
Edited by WisdomAugust at 2019-6-13 13:11

Press Data Output key to enable digital generator function.

The backlight of the key become light in yellow. [attach]2940[/attach]

The digital generator interface is opened and output the signal at the same time.

[attach]2936[/attach]

Digital Generator Interface

[attach]2937[/attach]

Signal Display on Logic Analyzer

Author: WisdomAugust Time: 2019-6-13 13:15

Press Function softkey to set the function as sync signal, programmable signal and turn off function.

When select function as Sync, the digital generator output synchronized signal of CH1 or CH2.

[attach]2941[/attach]

When select the sync signal source to CH1

[attach]2942[/attach]

When select the sync signal source to CH2

[attach]2943[/attach]

Author: WisdomAugust Time: 2019-6-14 08:03

Open CH1 waveform output, Select the Signal Type to "Sine ", frequency to “1KHz”,

Amplitude to 1V, Y Offset to 0V.

[attach]2947[/attach]

Author: WisdomAugust Time: 2019-6-17 08:01

Connect Digital Generator Terminals to LOGIC Analyzer Terminals to measure. The output signal of

D0-D15 terminals is a square waveform (3.3V, peak- to- peak).

[attach]2954[/attach]

Author: WisdomAugust Time: 2019-6-18 08:11

Programmable Signal

Select function to Prog, use the direction keys [attach]2956[/attach] and

knob [attach]2957[/attach] to modify the value for D0~D15 to 0 or 1.

[attach]2958[/attach]

Programmable Signal: Users can edit digital signal.

Author: WisdomAugust Time: 2019-6-19 08:53

The corresponding terminals will output high level or low level. When the data is set to 0, the corresponding

output voltage is 0V.

When the data is set to 1, the corresponding output voltage is 3.3V.

Such as, D0~D7: 10101010, D8~D15: 01010101, in the figure below.

[attach]2960[/attach]

Programmable Signal D0~D7: 10101010, D8~D15: 01010101 Display on Generator

[attach]2961[/attach]

Programmable Signal D0~D7: 10101010, D8~D15: 01010101 Display on Logic Analyzer

Welcome to Electronic Engineer Discuss (https://eediscuss.com/)