Title: HANTEK DSO1062B Shutdown problem [Print this page] Author: zkakuszi Time: 2019-11-27 21:49 Title: HANTEK DSO1062B Shutdown problem Hi, I just bought a Hantek DSO1062B oscilloscope.
At the first time switched it on .. after on minute went to shutdown.
I set it correctly to 90 Mins .. confirm it .. and no difference, it switced off after a minute.
It is very disappointing .. is there any solution?
The firmware seems the newest ..
Author: ying Time: 2019-11-28 08:55
Firstly, please make sure the battery power is enough. you can see the power mark at the top-right corner.
Besides, if you do not operate the unit for two minutes, the display backlight will close, you can press any button to light.
Author: zkakuszi Time: 2019-11-28 15:29 Edited by zkakuszi at 2019-11-28 15:31
well, the battery power is enough, ... full green .. and with and without charger is same
it is switching off exactly ... at one minute
thanks
Author: amy Time: 2019-12-12 15:52
Sorry to reply you so late. Looks like a hardware failure. Please contact your seller to return factory for repair.
Welcome to Electronic Engineer Discuss (https://eediscuss.com/)