Title: Issue WITH 1008c output channels [Print this page] Author: 1988Oleg1988 Time: 2020-2-10 23:24 Title: Issue WITH 1008c output channels Hello!
Please tell me whether it is possible to set the signal form on the programmable output channels 1008C?
How can I read and edit the file format *.squ that accepts oscilloscope software?
Author: ying Time: 2020-2-11 10:09
Please download the manual and refer to Chapter 3.13 Generate Square Waveform to generate and output the signal. http://www.hantek.com.cn/en/ProductDetail_13_13170.html Author: 1988Oleg1988 Time: 2020-2-11 12:22
thank you for the answer, but I asked about something else.
Is it possible to use a signal generator to organize a sine wave instead of a square signal?
In addition, the manual does not describe working with output channels A0, A1 what it is and how you can manage them.
Can I use a third-party application to create a file for the signal generator? Author: amy Time: 2020-2-14 15:47
The generator can't output sine wave.
A0 and A1 are empty pins and have no corresponding function.
And no third-party software is available. Author: JSM_Garage Time: 2021-9-26 23:25
Go to JTAG Connectors and Interfaces to learn how to interface with the output connections.
Please re-post if you have any luck. I am also interested.
Regards,
Welcome to Electronic Engineer Discuss (https://eediscuss.com/)