Electronic Engineer Discuss

Title: 上位机的显示界面上的测量选项能否固定显示 [Print this page]

Author: lucky Time: 2020-3-8 12:44
Title: 上位机的显示界面上的测量选项能否固定显示
Edited by lucky at 2020-3-8 12:44

虚拟示波器的显示界面上的测量选项能否固定显示？每次重启软件就要重新设置一下很不方便。
我用的是HANTEK6074BC , 上位机是HANTEK6000 VER2.2.5.每次设置好测量选项后，退出软件，下次再打开，那些测量选项就没了，又要重新设置一次，很不方便。有没有其它版本或软件可以把选定的测量先项固定下来，不要每次打开软件都要重新设置一次？这个功能很实用。或者把版本升级一下？
[attach]3439[/attach]

Author: wangshuang Time: 2020-3-9 11:32
用户可以通过“文件->保存配置/载入配置”来保存或调出包括时基、伏格、触发等设置。测量和光标的设置需要用户根据每次的需要单独设置。

Author: lucky Time: 2020-3-9 22:21
这样真的很不方便啊。能否升级下把这些设置自动保存，下次打开不要再设置一次了。这些功能很实用。

Author: wangshuang Time: 2020-3-10 10:10
好的，我会把您的建议反馈给开发人员。

Author: chhanchal001 Time: 2024-2-8 19:03
Note: The author has been banned or deleted.

Author: chhanchal001 Time: 2024-2-8 19:07
Note: The author has been banned or deleted.

Author: chhanchal001 Time: 2024-2-8 19:11
Note: The author has been banned or deleted.

Author: chhanchal001 Time: 2024-2-8 19:13
Note: The author has been banned or deleted.

Author: chhanchal001 Time: 2024-2-8 19:17
Note: The author has been banned or deleted.

Author: chhanchal001 Time: 2024-2-8 19:19
Note: The author has been banned or deleted.

Author: chhanchal001 Time: 2024-2-8 19:22
Note: The author has been banned or deleted.

Author: chhanchal001 Time: 2024-2-8 19:25
Note: The author has been banned or deleted.

Welcome to Electronic Engineer Discuss (https://eediscuss.com/)