Title: New DSO2c10 broken, calibration error [Print this page] Author: Mik3 Time: 2021-10-21 04:21 Title: New DSO2c10 broken, calibration error Edited by Mik3 at 2021-10-21 04:23
Hi, channel 1 trace on my scope wont center, its as if there a DC voltage offsetting the trace, I only bought it last month and only used it a few times, I tried to use it tonight to test a low pass filter and the trace is right at the top of the screen. So I tried to calibrate it and it gives this error 510d6, I tried rebooting several times and then tried a different firmware but nothing works.
[attach]4600[/attach][attach]4601[/attach] Author: Jing Time: 2021-10-23 09:59
Please make sure to warm up for at least 30 minutes before calibration. Author: tauirene2007 Time: 2021-11-2 11:48
hi,
my new DSO2D10 do the same.
Calibration does not work even after 2 hours warming up.
Hardware failure ? or only software Author: Jing Time: 2021-11-3 09:02
Please send your questions to support@hantek.com. Author: OLMa Time: 2022-1-31 04:52
Hi, channel 1 and 2 trace on my scope same wont center, its as if there a DC voltage offsetting the trace.
Hardware failure ? or only software?
Welcome to Electronic Engineer Discuss (https://eediscuss.com/)