Title: Hantek DSO5102P Self Calibration Error 0x802 [Print this page] Author: mjmnz Time: 2021-12-7 12:23 Title: Hantek DSO5102P Self Calibration Error 0x802 Hi I have a DSO5102P, when performing a Self Calibrarion it gets to step 27 of 38 and fails with the error message "Self calibration failed with error 0x802"
It appears this is associated with the calibration of Channel 1.
How can I fix this please?
Maurice
Unit Details
SW Version: 3.40.0(180120.01)
hw version 1010xffff8108
Serial number T1G/138016849
Author: Jing Time: 2021-12-8 11:14
When you are performing self-calibration, did you calibrate after warming up the engine 30 minutes in advance? And when calibrating, no line can be connected to the oscilloscope, and there can be no input signal.
Author: mjmnz Time: 2021-12-9 11:56
nk you for your reply,
I would have said yes to your questions but ran the self calibration again ensuring that no probes were connected. Self test passed this time. That's good - sorry to have wasted your time.
Is there a file that lists the meaning of the error codes? Author: Jing Time: 2021-12-9 13:42
I would have said yes to your questions but ran the self calibration again e ...
Sorry, there is no such file at the moment. Author: My_long_id@yahoo.com Time: 2022-3-5 08:52
Hi Sir, i got similar problem error 0x802. I did follow the calibration procedure, i disconnect all input and wait after 30min or so before self calibration. How ever the error remain the same at the exactly the same step 27 any suggestion ? Please. Author: litcogb Time: 2022-4-21 03:12
Hi guys, have same issue with my DSO5102P on step 25/38
Any thoughts?
Welcome to Electronic Engineer Discuss (https://eediscuss.com/)