Title: 4032L - USB malfunction or missing drivers [Print this page] Author: lpavl Time: 2024-1-25 19:04 Title: 4032L - USB malfunction or missing drivers Hello!
I have just bought a new Hantek 4032L device.
When I plug it into the PC, it says: USB device malfunctioned or has a missing driver. I have tried to load the drivers from the mini CD and the latest drivers from the product page.
The problem remains, the device is not installed properly. I think the USB enumeration fails, so the drivers are not recognized for this device.
When I plug the power cord to 4032L, the red LED at the top goes ON about 1-2sec after power up and remains ON permanently. If I plug the USB to the computer or disconnect it, the red LED is always ON. Is this correct?
Do I have a hardware malfunctioned 4032L? I have tried to install it on three different computers: Win7 32-bit, WinXP 32-bit and Win10 64-bit. The device does not install, drivers do not work.
Please help!
Thank you very much
Author: lpavl Time: 2024-1-29 21:21
To reply to myself, there was a manufacture error - a soldering joint that made a short circuit to USB line. Author: chhanchal001 Time: 2024-2-8 19:28
Note: The author has been banned or deleted.Author: chhanchal001 Time: 2024-2-8 19:33
Note: The author has been banned or deleted.Author: chhanchal001 Time: 2024-2-8 19:36
Note: The author has been banned or deleted.Author: chhanchal001 Time: 2024-2-8 19:38
Note: The author has been banned or deleted.Author: chhanchal001 Time: 2024-2-8 19:43
Note: The author has been banned or deleted.Author: chhanchal001 Time: 2024-2-8 19:49
Note: The author has been banned or deleted.Author: chhanchal001 Time: 2024-2-8 19:51
Note: The author has been banned or deleted.Author: chhanchal001 Time: 2024-2-8 19:54
Note: The author has been banned or deleted.Author: chhanchal001 Time: 2024-2-8 19:56
Note: The author has been banned or deleted.
Welcome to Electronic Engineer Discuss (https://eediscuss.com/)