Title: Hantek HDG2002B Factory Reset? [Print this page] Author: luke Time: 2016-11-9 08:43 Title: Hantek HDG2002B Factory Reset? Hi, I'm a newbie here, so apologies in advance if this question has already been answered, but I did try searching for it first!
I have a Hantek HDG2002B which will not turn on, it will only display a blue screen with the message "Sorry, the application has no response! The system will restart after 30s"
It is stuck in a loop and displays the same message again after it restarts, or if I switch it off and on again; removing the backup battery does not help!
I was trying to edit an arb waveform and think that I might have changed some settings incorrectly, so is it possible to reset the factory default settings, maybe with a jumper on the PCB?
Earlier I had installed the latest firmware from the Hantek website (afg_hdg2000b_160411.upk) and it was working OK after this, although there were some crashes with the same message displayed, but the unit recovered from these after a power cycle
The serial number is DDS2300248
Any help or advice would be greatly appreciated!
Author: amy Time: 2016-11-11 11:55
Please contact your seller to repair.
Welcome to Electronic Engineer Discuss (https://eediscuss.com/)