Title: Hantek DSO4254C not working anymore [Print this page] Author: krjdev Time: 2018-9-21 22:09 Title: Hantek DSO4254C not working anymore Hello,
Yesterday the oscillosope arrived. I have tested it and it was working.
Today I started a measure, to check the features of the oscilloscope, but it doesn't work anymore. I used the single shot function (Single button) and after that I pressed the Run/Stop button, the Run/Stop button blinks red and green very fast and then it didn't responds to any button press. So I powered off the oscilloscope. Maybe a software bug. Now when the power-on switch is pressed, the oscilloscope hangs when the Hantek logo appears. Is there a way for a hard reset? I can't find any information for this in the user manual.
Author: amy Time: 2018-9-26 12:56
Sir, please press Power button to turn on, press Power button to turn off before the LCD screen is lit.
Now press Power button to turn on again.
If there is a figure like the picture, please press "recover the system" option to do.
[attach]2291[/attach]
Author: ying Time: 2020-9-24 10:45
Please refer to the video to recovery system:
Author: Bieli Time: 2021-2-11 21:09 Edited by Bieli at 2021-2-16 17:37
Hello,
I have same situation when shitching Single to RUN/STOP both buttons light up RUN/STOP start blink and DSO hang up. After turning it Off nad On DSO hang on initialisation screen.
I tried recovery procedure you describe but receive "Operation fail"
Pls send recovery partition file for DSO4084C.
Regards
Welcome to Electronic Engineer Discuss (https://eediscuss.com/)