|
I have a Hantek 6022BE which works as described but there are 2 changes I
recommend to improve your software.
1. Currently one trace is yellow. Is there any method to change the
colours of the individual traces? When I print the screen, the yellow
trace is almost invisible.
2. As shown by the file attached to this email, your competitors in the
digital oscilloscope industry have an extra function that enables the
operator to select the display position of the triggering point.
As quoted in the enclosed file ' Marker shows the trigger position. This
also indicates the horizontal position since the Horizontal Position
control actually moves the trigger position horizontally.'
All the other features are available with your software but the ability to
set the position on the screen to the trigger point as selected by the
operator is a definite advantage which your software lacks.
Page 31 of the Hantek manual states 'If The oscilloscope wants to acquire a
waveform, it collects enough data so that it can draw the waveform to the
left of the trigger point.
Therefore, it seems to me that the only aspect lacking from including this
feature in your software is the selection of the position of the trigger
point by the operator.
|
|