|
Hey amy. There is a wish to refine the firmware. If I use a generator and an oscilloscope for the circuit under study and I need to quickly change the frequency of the signal, then I cannot do it.
For example.
I need to scan the oscillating circuit in frequency from 35.00 kHz to 45.00 kHz. I run the AWG at a frequency of 35.00 kHz, go to the Scope page and look at the picture. Ok. Then I return to the AWG page and I want to set 35.01kHz, but I can't! First I need to go to the tab such as the "Amp" of the generator and then return to the "Freq" tab.
And only after that I can change the frequency of the signal.
|
|