Hantek2000 bugs and wishes (2c42,2d42,2c72,2d72)

amy · Post time 2019-1-4 10:20:11

About the calibration problem, please refer to the following post and download the latest firmware to update.
https://www.eediscuss.com/forum. ... amp;extra=#pid16428

About the "DC mA" problem, please connect two red and black pens to the mA test ends and shorten them, what is the current value displayed?

amy · Post time 2019-2-13 09:40:47

AxGxP replied at 2019-1-18 04:36
New bug found!

Cant measure more then 399V DC or AC in DMM mode.

Sorry, there is a mistake in the manual about the drop voltage in diode mode. It should be 1V

amy · Post time 2019-2-15 16:05:39

Edited by amy at 2019-2-15 16:06

罐头瓶子 replied at 2019-2-13 10:47
关于bug的反馈：
二极管档测量LED灯，灯不亮，不显示导通电压。二极管，三极管测量很鸡肋。
万用表功能经常 ...

二极管只能测试1V导通电压，发光二极管导通电压大于1.6V了，点不亮。
测电阻和刷新太慢，请先参照下面的帖子升级固件和FPGA
https://www.eediscuss.com/forum. ... e=1&extra=#pid16427
https://www.eediscuss.com/forum. ... e=1&extra=#pid16427

如果还有问题，请拍视频给我们

amy · Post time 2019-2-22 08:39:11

Edited by amy at 2019-2-22 08:41

罐头瓶子 replied at 2019-2-18 08:37
有什么方法请告知，把二极管测试提高到2-3v。我接受改装，这个功能在维修工作中占据着很重要的位置。
还 ...

把二极管测试提高到2-3v，这个硬件就完全不一样了。

如果必须这个功能，您可以考虑DSO1000B系列，这个可以点亮发光二极管。

amy · Post time 2019-3-13 13:58:58

alik3t replied at 2019-3-12 20:56
Dear amy

I understand that it is impossible to execute all the Wishlist, but the display in the mea ...

Sorry, you can use cursor to measure more parameters.

amy · Post time 2019-3-28 11:59:57

Sorry, the measurement rate is determined by hardware. Can't be improved by firmware.

amy · Post time 2019-4-9 15:23:18

We haven't developed WiFi module software yet.

amy · Post time 2019-5-25 16:21:36

Ok, I have given feedback our engineer. Will be modified in the next firmware.

amy · Post time 2019-6-11 09:30:12

Joker22 replied at 2019-6-7 00:12
您好，当我在DMM模式下测量电压和电流时，可以选择显示MIN / MAX值吗？

不好意思，不可以。

amy · Post time 2019-7-9 13:55:33

Sorry, we do not plan to add.