Hantek2000 bugs and wishes (2c42,2d42,2c72,2d72)

uu5jhu

Hey amy. There is a wish to refine the firmware. If I use a generator and an oscilloscope for the circuit under study and I need to quickly change the frequency of the signal, then I cannot do it.

For example.

I need to scan the oscillating circuit in frequency from 35.00 kHz to 45.00 kHz. I run the AWG at a frequency of 35.00 kHz, go to the Scope page and look at the picture. Ok. Then I return to the AWG page and I want to set 35.01kHz, but I can't! First I need to go to the tab such as the "Amp" of the generator and then return to the "Freq" tab.     
And only after that I can change the frequency of the signal.

uu5jhu

uu5jhu replied at 2019-5-17 05:21
Hey amy. There is a wish to refine the firmware. If I use a generator and an oscilloscope for the ci ...

The exact same story with the generator voltage. If you set 1.0V then jump to the oscilloscope page and back, then using the buttons (arrows) you can no longer handle the generator voltage !!!

uu5jhu

Hi Amy
There is a great desire to have on board also a sweep generator. Is it possible to implement this in the Firmware / Software?