DSO5202B firmware updates fail with 0xfe

BeanieBob

I had this problem before with files not visible.
I suspect the USB partition cannot be mounted because the drive capacity is too large.
I was able to use an old 512MB  USB stick successfully.

Can you try with a small capacity USB drive - or possibly create a small partition
if you do not have an older USB stick. Hope it works for you.   

( I am not from Hantek - just a user - so this is not official advice)

JSP40

I have the same problem.
DSO5202P
Firmware update failed error 0xfe
No upgrade files detected on USB device

amy

Sorry, there is no upgrade firmware suitable for your oscilloscope.

cdidier

Hello Amy,

I have the same problem too. But my firmware is quite older:
Model: DSO5202B
SW: 2.06.3(120808.0)
HW: 10070x555583e9

What is the procedure to update my device?

amy

Slash200 replied at 2020-2-4 03:54
Dear Amy,
I have the same problem.
Model: DSO5202B

Sir, You can upgrade with the above firmware.

Slash200

Dear Amy,
I have the same problem.
Model: DSO5202B
SW: 2.06.3.(130425.0)
HW: 10070x555583e9
I can't update from the downloads from the hantek page.
Also your attached update shows me the error 0xfe
Can you please help me updating my DSO?

Thank you!
regards

amy

Sir, the linux version of your scope is 2.06.3. The latest firmware is not suitable for it.
Please use this firmware to update.


Attention, if the firmware version number earlier than 2013, such as 120505.0 or 120825.0, please do not upgrade with this firmware.

dgScope

I did follow up with support@hantek.com and haven't received a response.

My question to Support is:  What’s the highest supported firmware version for the DSO5202B with hardware version (0x555583e9)?

Thanks.

amy

Sir, your scope is too old, the new firmware is not suitable for it.
Please send a message to our email support@hantek.com