How to Use the Burst Function of HDG6000B?

WisdomAugust

Produce a burst using harmonic.

The Harmonic key light when using harmonic wave.

Burst display on generator when using harmonic wave.

Display on oscilloscope when using harmonic wave.

WisdomAugust

Produce a burst using pulse

The Pulse key light when using pulse wave.

Burst display on the generator when using pulse wave.

Display on an oscilloscope when using pulse wave.

WisdomAugust

Produce a burst using ramp.

The Ramp key light when using ramp wave.

Burst display on generator when using ramp wave.

Display on oscilloscope when using ramp wave.

WisdomAugust

Produce a burst using square.

The Square key light when using a square wave.

Burst display on the generator when using square wave.

Display on an oscilloscope when using square wave.

WisdomAugust

Burst display on the generator when using sine wave.

Display on the oscilloscope when using sine wave.

WisdomAugust

Burst Mode

You can configure the function generator to output a waveform with a specified number of cycles, called

a burst. The function generator can produce a burst using sine, square, ramp, pulse, harmonic or arbitrary

waveforms (noise is allowed only in the gated burst mode and dc is not allowed).

Produce a burst using sine.

The Sine key light when using sine wave.

WisdomAugust

Oscillscope display when using a manual trigger

? The Trigger key is disabled when a function other than burst is currently selected (or when

the output is disabled). A message

pop up in display when using a manual trigger.

WisdomAugust

To Trigger a Burst

You can issue triggers from the front panel for bursts using a manual trigger or an internal trigger.

? Internal triggering is enabled with the default settings of the function generator. In this mode, the

function generator outputs continuously when the burst mode is selected.

? Manual triggering initiates one burst each time you press theTrigger key from the front-panel.

Continue pressing this key to re-trigger the function generator.

Generator display when using a manual trigger

WisdomAugust

5 View the waveform.

To view the waveform parameters.

Note:

A. You can generate a single burst (with the specified count) by pressing the Trigger key.

B. You can also use an external gate signal to either turn the burst signal “on” or “off” based on the

external signal applied to the front-panel Sync/Mod/Trig connector.

WisdomAugust

3 Set the burst count.

Press the countsoftkey and then set the count to “3” using the numeric keypad or knob.

4 Set the burst period.

Press the period softkey and then set the period to 10 ms using the numeric keypad or the knob and cursor

keys. The burst period sets the time from the start of one burst to the start of the next burst.

At this point, the function generator outputs a continuous three-cycle burst (if the output is enabled).