"self calibration failed, error x10b00"

amy · Post time 2019-8-2 08:48:38

Please test these six points voltage.1 2.5V
2 -2.88V
3 1.8V (1 and 8 pins of U203)
4 +5V/-5V (6 and 7 pins of U203)

alper · Post time 2019-8-4 02:37:35

Edited by alper at 2019-8-4 02:42

Please test these six points voltage.1 2.49V
2 -2.97V
3 1.pin=2.40 and 8.pin=2.41 of U203)

amy · Post time 2019-8-5 11:48:59

Please test the voltage of this magnetic bead. It should be 12V.

alper · Post time 2019-8-6 04:30:06

"Please test the voltage of this magnetic bead. It should be 12V."

11.98V

alper · Post time 2019-8-6 05:45:04

Edited by alper at 2019-8-6 05:48

I think I found the fault.I removed D02_1 diode and voltage values returned to normal,ch2 line came back. But I did not have a full test because I do not have bav99 in my hand. I ordered the diode I will share the result with you

amy · Post time 2019-8-6 14:36:21

Ok. Hope for good results.

alper · Post time 2019-8-14 03:47:41

hi amy i changed d02_1 diod and everthing is ok. Ch_2 is working and self calibration ok.Thank you for help.

"self calibration failed, error x10b00"

This post contains more resources

This post contains more resources

This post contains more resources

This post contains more resources