Good day. The oscilloscope has stopped responding to signals. Does not respond to the autoset button. I tried to flash on usb. Did not help. How to completely upgrade linux system.
Sir, in your picture, the CH1 has waveform, but in your video, the CH1 doesn't have the waveform. I'm a little confused.
Please use the CH1 to measure the square the lower right corner of the scope, whether the oscilloscope display square wave.
good day. I hooked the shyyups to the internal generator. but nothing happens. The autoset button is not active. Channel select buttons also do not light. Previously, all buttons lit up when pressed. autoset also regularly calibrated the channel. but once turning on the oscilloscope everything stopped working. updating via usb did not help. It seems to me that it is necessary to completely reinstall the system.
I shot an extra video. here is the link. https://yadi.sk/i/0hTaSlmZF5NKrA
The device was bought on aliexpress. I am in Russia. This is a problem for me. Most likely it will not work to send it back. I found the video on the Internet. man had the same problem. he eliminated it by flashing the system. I would also like to try.
Please send me the installation files for linux. I can install rs323 through the bootloader.
Post time 2019-8-7 16:13:23
Favorites
Shares
Collection
Author
Post time 2019-8-12 11:05:17