Hantek 2c42 new out of the box does not turn on

fast363 · Post time 2019-9-11 19:16:31

Link to video: https://youtu.be/RfAH-8GrchQ

amy · Post time 2019-9-12 09:58:01

First, please measure the voltage of the battery.
If the voltage is about 3.7V, the oscilloscope still can't turn on, please operate as follows.
1. Remove batteries.
2. Keep press F1 and connect the scope to your computer with the USB cable at the same time.
3. Please check whether the button on the lower right corner is flashing red and green like the video.

Han · Post time 2019-9-12 11:02:54

fast363 replied at 2019-9-11 17:08
Batteries charged in another charger

Try to remove the batteries and charge,to see if the button is lit

fast363 · Post time 2019-9-12 13:30:26

amy replied at 2019-9-12 09:58
First, please measure the voltage of the battery.
If the voltage is about 3.7V, the oscilloscope sti ...

Hello, amy! I did everything as you wrote, but not a single button is lit or flashing. Apparently the problem is more global

fast363 · Post time 2019-9-12 13:35:48

Han replied at 2019-9-12 11:02
Try to remove the batteries and charge,to see if the button is lit

The batteries are charged in another charger. Voltage 3.9V After installation in the device, the buttons do not light.

amy · Post time 2019-9-17 11:05:51

fast363 replied at 2019-9-12 13:35
The batteries are charged in another charger. Voltage 3.9V After installation in the device, the ...

If you can use TTL tool, please refer to this to program arm1 and arm2.

https://fil.email/0KfXD3Ks

fast363 · Post time 2019-9-18 10:57:08

Thank you all, the problem is resolved.

Hantek 2c42 new out of the box does not turn on

This post contains more resources