Hantek 2D82Auto Firmware

Pav

I got this Oscilloscope from Bangood with same buggy firmware ,that didn't display English. It was looking like just random pixels, instead of alpha/numerical characters.

Newer firmware fixed it.  

I'll keep it short , and simple. Here's is how I got it fixed in first try.

At first ,it wasn't clear to me how to enter DFU mode so:
1 Remove the battery back cover and remove 2 batteries
2 Unplug the USB cable
3 Press and hold F1, plug in the USB cable and connect to the computer.
4 Release F1 immediately after the lower right corner (RUN/Stop) light flashes <--I released the F1 button just after when I saw the green light on ,|> (the play/pause button on the unit).
5 Click the program "Start" button
**Note, please make sure the computer has successfully installed the DFU driver!

The Hantek website link: Hantek2D82AUTO

This was done with windows 7 64-bit.
The rest info is in the pictures. Please read, before do.
Hope it helps.
Ps: I notest the pictures doesnt show up on some devices. Please let me know if you can't see them below.
Also You have to create an account on this website, and to be loggen in, to see them.