Hantek 2000 boot logo

uncle_sem

Hello! There is a "boot logo on/off" in menu, but currently boot logo is a black screen, i guess - or it's look like a black screen. So, is it possible to change it to something else?

Han

You can use upper software to change it.

uncle_sem

sorry, don't get it - which software is it? hantek2000_software.zip?

uncle_sem

found it! but is it possible to use some picture , not just a few text lines?

amy

Sorry, cannot add picture as boot screen.

mostorer

uncle_sem replied at 2019-11-8 19:09
found it! but is it possible to use some picture , not just a few text lines?

Hi there. May I kindly ask you what the software to be used is ?

OASJ2YSeeEhBQo1

mostorer replied at 2020-4-21 16:06
Hi there. May I kindly ask you what the software to be used is ?

Just use the software that came with the device. Go to the menu Utility -> SetBanner

You can write a text message for each line and it will show on the screen of the oscilloscope during its startup. Nothing very useful really.

any1ne

OASJ2YSeeEhBQo1 replied at 2020-4-22 08:02
Just use the software that came with the device. Go to the menu Utility -> SetBanner

You can writ ...

Not working.

OASJ2YSeeEhBQo1

any1ne replied at 2020-4-24 08:51
Not working.

Which version are you using of FW, FPGA and PC software?

The message is saying to update your firmware, have you tried that? I just tried here and it works.

mostorer

OASJ2YSeeEhBQo1 replied at 2020-4-24 13:06
Which version are you using of FW, FPGA and PC software?

The message is saying to update your fir ...

Yes, I can confirm. It happened the same to me.

It asked me to update Arm2. Then I did the update and finally it worked.
I would have create a small logo/picture using ASCII ART, but only 15 chars per line with no monospaced font.