DSO5102P Rotary knobs not working

BeanieBob

Hi All.

My oscilloscope's front panel was working perfectly before but now is giving me issues.
It is a Hantek DSO5102P and I got it only two years ago through Amazon.

* NONE of the rotary knobs on the front panel work
* All the push buttons work including AutoSet EXCEPT  
       Trigger buttons which have responded for a time with the incorrect action
       but appears to be working now.

  I HAVE ALREADY
    * Re-seated the cable at both ends that joins keyboard PCB
    * Performed firmware update
    * Connected from oscilloscope rear USB to PC and can confirm that through the
       PC software it is possible to perform the rotary actions such as Volts/Div setting.

Technically I think the unit is still in warranty - but presume this involves a lot of trouble.
  I would appreciate any help if you have any direction on how I should try to
  get the unit working again,


many thanks in advance

BeanieBob

Thank you wangshuang - but I cannot find a local agent to supply the PCB. Can you please advise who is the agent to supply parts for UK/Ireland, or even Europe. Where can I source this part without it costing more than a new oscilloscope? Please advise?

  If possible, can you please advise which parts on the board are likely to fail - I don't mind repairing myself. Thank You :-)
  ( I have repaired other boards in the past and learnt that the same parts fail again and again )

BeanieBob

Thanks wangshuang,
But after performing Default Setup the problem is the same - rotary knobs still not working.

Please can you get some feedback from your technical team - what components normally fail on the
keyboard PCB so I can try to repair. Or where I can get a replacement keyboard PCB at reasonable cost.
( You appear to be sure it is this PCB, and not main control board )   

It is very difficult to use the equipment in this state. Any help is appreciated - including
further diagnostic suggestions - although i do not have another oscilloscope.

Thanks.


  

BeanieBob

Thanks wangshuang.
I have sent you serial number by private message

BeanieBob

Hi wangshuang.

I have sent you serial number by private message and I am waiting for your
reply from last week. Can you advise if there is an easy repair for this or
do i need to follow up on the warranty.

thanks.