Can the Hantek 6074BC support UART decoding ? If so How do I set it up?

KeenAmateur

Thank you for your response.. i have three questions,

1) Where is the decoded data displayed? I assume the Data field in the trigger box (blue star) is the trigger data mask?

2) What does Table do? (purple marker)

3) What does the Connect colours mean (Red marker).. mine flicks between, grey, orange... is that correct? The 6074BC has a green LED above the CH1 connector.

wangshuang

6074BC supports UARTdecoding, decoded data is displayed in hexadecimal.

KeenAmateur

I have had a play and been able to trigger off the Stop bit when selected as long at the trigger threshold is above the waveform and also the data field however it won't trigger off the input data field.. tried hex binary and decimal.. seems to be Hex 0-F as won't accept ascii values.. if I type "U" from the terminal n,8,1 115200 and put 55 in the data field it triggers on any value.. not just 55. I want to trigger on a data value and then scroll along the data steam to find any issue.

how do I successfully set the trigger data mask?