MPO6002EDU Series Oscilloscope Guide

WisdomAugust · Post time 2022-6-6 17:34:25

For example, Edit Expression can be used to take the absolute value of a waveform. To do this, press Clear

on the keypad. Use the V0 knob or touch screen gesture to select Abs(, and then select the channel.

Select again using the V0 knob or touch screen gesture ). Press Enter. The signal is absolute.

WisdomAugust · Post time 2022-6-7 16:08:01

Absolute Value

The absolute value function changes negative values in the input to positive values

and displays the resulting waveform.

Example of Absolute Value

WisdomAugust · Post time 2022-6-8 18:34:07

Edited by WisdomAugust at 2022-6-9 16:26

Digital Channels

To connect the digital probes to the device under test

1 If necessary, turn off the power supply to the device under test.

Turning off the power to the device under test would only prevent damage that might occur if you accidentally

short two lines together while connecting probes. You can leave the oscilloscope powered on because no

voltage appears at the probes.

2 Connect the digital probe to the DIGITAL connectors on the mixed-signal oscilloscope by the Type C cable.

The digital probe is keyed so you can connect it only one way. You do not need to power-off the oscilloscope.

CAUTION Probe cable for digital channels Use only the Hantek logic probe and accessory kit supplied with the

mixed-signal oscilloscope.

WisdomAugust · Post time 2022-6-9 16:27:52

3 Connect the ground lead on each set of channels (each pod), using a probe grabber. The ground lead improves

signal fidelity to the oscilloscope, ensuring accurate measurements.

WisdomAugust · Post time 2022-6-10 16:08:35

4 Connect a grabber to one of the probe leads. (Other probe leads are omitted from the figure for clarity.)