Hantek 6022BL software/hardware

LarsAA

Hi

Just bought the Hantek 6022BL, and are far from impressed - besides very weak software, I wonders if the hardware actually works as intended. Can someone please comment on the following:

- Seems like there is (at least) two variants of the hardware for 6022BL (and maybe for 6022BE), with (at least) some differences in the analog input section (input divider section), and maybe also in the use of extra USB signals. Is that true?
-- If so - does the software work for both version or not? I can observe, that the input divider does not work proporly on my 6022Bl, but I do not know whether this is a software or a hardware problem.
--- If not, then where can I find the software for my scope (mine is NOT using same OpAmp for the two stages in the analog section, and using a different resistor map for the divider, than the other board).

- Can anyone confirm (or the opposite) that the SDK supplied with the 6022Bl actually works?

I have tried an open source "OpenHantek6022" software (which is far better than the official Hantek software), but is still having the input scaling problem (besides some other issues). Also tried the SigRock framework, with some luck, but this does not provide the needed Scope functionality.

Please help me out here: If I am not getting some software that actually works (including the software needed for controlling triggerpoint), the scope is 100% useless. I have completely given up on the "Logic Analyzer" part (this software is so bad that I cannot even begin to investigate whether this part of the hardware works) - I only hope for using the scope.

/Lars