|
Edited by tblock at 2021-1-20 20:37
Hello,
I am using the above firmware on my DSO2D15.
I found following issues I want to publish.
Hantek DSO2D15 Bugs (Firmware 1.1.1.0 20210105.00):
-------------------------------------------------------------------------
- UART Protocol
- Disp Monitor
- only shows 6 values, no scrolling for more entries possible
- the numbers 0 to 5 are overlayed by the 0x…….. values.
- The shown values in list do not match the values shown on the channel signal
- Disp Sync
- Sometimes only an empty line is shown on the screen.
- Sometimes I get two overlayed lines.
Performance issues
- Horizontal Position change
- Screen update is delayed. So changing the trigger position is poorly possible.
Will these issues be addressed?
|
|