2D72 Firmware update failed

killermux@gmail · Post time 2019-5-22 17:48:26

Hi, during the firmware update of 2D72 the process was termintated and the unit does not power on anymore. Please help!
Flashing key POWER and all.

purge · Post time 2019-7-14 08:21:26

Thanks Army. I saw a message there that said to hold down F1 and then plug into pc. When pc recognises the Hantek to lift finger off F1. It entered DFU mode and I managed to repair the firmware.

OASJ2YSeeEhBQo1 · Post time 2019-7-12 00:26:56

Have you installed the Dfuse driver first? https://www.st.com/en/development-tools/stsw-stm32080.html

Also check the eevblog forum thread about these devices, you can find some more help there.
https://www.eevblog.com/forum/te ... 2485455/#msg2485455

purge · Post time 2019-7-11 15:44:51

Yes thank you army but that procedure did not work. I have tried it several times and the unit will not turn on or allow Power + F1. What else can I try? What is arm2? Can I try that?

amy · Post time 2019-7-9 13:34:58

https://www.dropbox.com/s/xop4sn ... ram%20Arm1.zip?dl=0
Please refer to this.

purge · Post time 2019-7-8 19:36:34

This did not work for me, still no power on. Please send link for arm2 or software to correct fault. Thanks

killermux@gmail · Post time 2019-5-23 22:23:09

Thanks all ok

OASJ2YSeeEhBQo1 · Post time 2019-5-23 09:37:59

Edited by OASJ2YSeeEhBQo1 at 2019-5-24 01:02

In the installation folder of the PC software (C:\Program Files (x86)\Hantek2xx2) there is a file named "rescure_en.txt" check it and see if it helps in your case.

2D72 Firmware update failed

Related collections: